GE IC697CPM925 Single slot CPU Module

Description

.Many products are not yet on the shelves please contact us for more products

.If there is any inconsistency between the product model and the picture on display, the model shall prevail. Contact us for the specific product picture, and we will arrange to take photos in the warehouse for confirmation

.We have 16 shared warehouses around the world, so please understand that it can sometimes take several hours to accurately return to you. Of course, we will respond to your concerns as soon as possible

GE IC697CPM925 Single slot CPU Module PLC CPUs 64 MHz, 32-Bit Floating Point Central Processing Unit,1 Mbyte Memory The CPM 925 is a single slot programmable controllerCPU which allows floating point calculations. TheCPM 925 CPU is programmed and configured byMS-DOS or Windows based programming softwareto perform real time control of machines, processesand material handling systems. It communicates withI/O and smart option modules over the rack mountedbackplane (IC697CHS750, 782, 783, 790, 791) by wayof the VME C.1 Standard format.Supported option modules include all IC697 LAN interface modules, several Coprocessor modules, BusController for IC660/IC661 I/O, Communications modules, and all of the IC697 family of discrete and analogI/O modules.

Features

Single slot CPU

Provides 1 Mbyte of battery-backed memory in thesame slot

Supports floating point calculations

12K inputs and outputs (any mix)

Up to 8K analog I/O

0.4 microseconds per boolean function

64 MHz, 80486DX2 microprocessor

Supports IC660/IC661 and IC697 I/O

Programmed by MS-DOS or Windows softwareproducts running on Windows 95 or WindowsNT over Ethernet TCP/IP or through the SNPport

Configurable data and program memory

Battery-backed calendar clock

Three position operation mode switch

Password controlled access

Remote programmer keyswitchmemory protection

Four status LEDs

Software configuration (No DIP switchesor jumpers)

Reference information inside front door

In-system upgradable firmware

Connecting your programmer via an Ethernet TCP/IPnetwork requires installation of an Ethernet Interfacemodule in the PLC. This can be either the EthernetController, IC697CMM741, or Ethernet Interface (Type2), IC697CMM742. Before connecting yourprogrammer and PLC to the Ethernet TCP/IP networkyou must set the IP address in the Ethernet Interface.After setting the IP address, connect the PLC and theprogrammer running Windows software to theEthernet Interface.For more detailed information on Ethernet TCP/IP,refer to the TCP/IP Ethernet Communications (Type 2)User’s Manual, and the Windows programmingmanual, GFK-1295